My first try was firmware-binstaller but after configuration a the installer sent a message saying that an unsupported B43 device was found. If you are still being prompted for entering your password make sure that you have enabled your pc to remember the password. How do you get the Broadcom BCM wireless card working? I had the same problem the packages were installed successfully but the card didn’t work. I’ve done a fresh install of Natty This question has been asked before and already has an answer.
|Date Added:||5 February 2010|
|File Size:||28.26 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Broadcom BCM57xx (Windows 98/ME) 10.24d
It turned out it had been blacklisted. I have a Broadcom BCM wireless network card and it failed to come up.
I would perhaps re install your drivers which should not take long Do this via a terminal and you should see if anything goes bcm575m So in a terminal type the following sudo apt-get remove bfwcutter firmware-binstaller then sudo apt-get install bfwcutter firmware-binstaller This should reinstall your wifi driver Alternatively what I have done is install the other broadcom proprietry driver Broadclm This was just as easy again via the terminal Clear out any older files sudo apt-get remove bcmwl-kernel-source sudo apt-get install bcmwl-kernel-source If you are still being prompted for entering your password make sure that you have enabled your pc to remember the btoadcom.
Roberto Stelling 11 1. The system listed it as “device not ready missing firmware “. How do you get the Broadcom BCM wireless card working? I have an older Gateway laptop with a Bxm5705m card. Home Questions Tags Users Unanswered. I had this same problem on a Dell Latitude D Not sure how to report this issue, but I think it’s a problem with the firmware installer package.
I’ve done a fresh install of Natty The following got my card working: Also have a Dell Latitude D Installing Broadcom Wireless Drivers 47 answers. See first answer in this question: After a bit of reading, I installed the bfwcutter and the firmware-binstaller.
If those answers do not fully address your question, please ask a new question. Now it will attempt to connect to the bgoadcom network and asks for the WPA2 password. Was you connected to network when you installed firmware-binstalleror just get the. This question already has an answer here: I had the same problem the packages were installed successfully but the card didn’t work. This works without any additional drivers.
Everything worked fine after I’ve installed bfwcutter and firmware-b43legacy-installer.
KEMP LoadMaster – Bare Metal Hardware Compatibility list | Singapore
It said no drivers installed. However after entering the correct password, bradcom still won’t connect and after a minute or so, it asks for the password again. I’ve checked the additional drivers list as apparently after installation of the b43 driver it should be listed but there is nothing there. After trying several times to install the firmware-b43legacy-installer I found an Intel card and replaced it.
Then I’ve removed firmware-binstaller broadvom installed firmware-b43legacy-installer.
If you are still being prompted for entering your password make sure that you have enabled your pc to remember the password.